B6083b47 6fa7 447b 9965 dd79469b8277


#bitify Fixing Tower of Pisa

by 3DPrintingGirls

Published on December 11, 2014

The unintended tilt of the Leaning  Tower of Pisa has been fixed with littleBits.

How To Make It


3D print adapter object. STL file located at http://www.thingiverse.com/thing:588294


Attach  a BYJ48 stepper motor to the adapter. More information about the stepper motor used at http://www.instructables.com/id/BYJ48-Stepper-Motor/


Carefully solder header pins to the additional I/Os available pins in the Ardunio bit. for easily connecting the stepper motor. Visit following link for valuable information about referred pins. http://discuss.littlebits.cc/t/using-the-additional-i-os-on-the-arduino-bit/1019


If needed assemble the Lego Leaning Tower of Pisa -http://architecture.lego.com/en-us/products/landmark/leaning-tower-of-pisa-21015- The tower will be raised by a partial stepper motor rotation.


Deploy the code provided below.

Related Projects

Runner - BitOlympics event at BONEVET

This project is created by little makers on BitOlympics event at BONEVET Makerspace, where the game of running&nbsp...

The police in traffic

In a dense traffic, only one policeman can do the job properly. Created with bits, Trimi and Albatros have found solutions for thi...

Remote Crib Communicator

This mobile notifies you via text message when your baby makes noise in the crib. You can also control the mobile remotely through...